This is the Nema 17 motor coupler for the Y axis project. 100% pla infill.

$ 40.00 To Have Item Printed (2x set)
NEMA 17 COUPLER.STL
This is the leadscrew bearing block A. You need one for each side of your Y axis where your Bearing ideler pulley was. It bolts inplace on the existing Gt2 setup! 75% infill Pla

$65.00 To Have Item Printed (2x set)
Y AXIS LEADSCREW BEARING BLOCK A.STL
This is the leadscrew bearing block B Right. You need one for the Right side of your Y axis where your 8mm or 5/16 drive shaft was. It bolts inplace on the existing Gt2 setup! Please note this has a 10mm extion that goes toward the existing block! 75% infill Pla

$35.00 To Have Item Printed (2x set)
Y AXIS LEAD SCREW BEARING BLOCK B RIGHT.STL
This is the leadscrew bearing block B Left. You need one for the left side of your Y axis where your 8mm or 5/16 drive shaft was. It bolts inplace on the existing Gt2 setup! Please note this has a 10mm extion that goes toward the existing block! 75% infill Pla

$ 35.00 To Have Item Printed
Y AXIS LEADSCREW BEARING BLOCK B LEFT.STL
You will need a pair of these, one for each side. They are designed to line up with your Y axis bearing blocks top and botton center 4 holes that attach to your side pannels.

$ 60.00 To Have Item Printed (2x set)
Y AXIS LEAD SCREW NUT BLOCK.STL
These are upgrade bearing block for root2 project for the Y axis. They are stronger. You will need to extent your limit switch contact points 13mm or 1/2.

$ 150.00 To Have Item Printed (4x set)
Y AXIS BEARING BLOCKS UPGRADE.STL
Here is a quick how to section with some pictures of how it works. This is designed to drop inplace of existing parts from Root 2 project.

How To Here!