This is an Ayncube bolt inplace Effector. Take your connection rods off. Drop in the effector into this unit. Use the same bolts to fassen it to the magnetic effector plate.

$35.00 USD To Have Item Printed

Anycubic Magnetic Trifector.STL
This is an Ayncube ball join carrier for the Trifector above.

$45.00 USD To Have Item Printed (Set of 3)

Anycubic Carrier Ball Mount.STL

This is a dual side air duct for anycubic kossel printers. 100% infill. Materials are up to the maker. I have used one out of pla with no issues for some time.

$20.00 USD To Have Item Printed

Anycubic Split Airduct.STL
This is an Ayncube optic probe. Offsets are around 55mm if you have a 6mm rod out the end. I used a pen spring, rc servo rod clamp and a paper clip for parts. Optical switch and the supplied magnet on the old switch.

$15.00 USD To Have Item Printed

Anycubic Optical Probe.STL
This is an Ayncubec hotbed plate clamp. Remove your old holders and use screws and nuts! simple as that! 40% infill is fine for this item in PLA

$45.00 USD To Have Item Printed (Set of 3)

Base Clip.STL